LED car headlight assembly loading steps

Step 2: Drive the car to a wide and flat place (preferably located 10 meters in front of the car) with a wall surface), and tighten the handbrake to stop;

Step 3: Open the low beam of the original car and illuminate it on the wall 10 meters away from the front of the car. Use electric tape to mark the turning center point below the cut-off line of the original car, and then turn off the engine and power supply.

Step 4: Loosen the hood lock, open the hood and fix it;

Step 5: Use the common tools for repairing vehicles (sleeve, screwdriver, etc.) to remove the front bumper or front grille of the car (note that it is placed face up), especially for Japanese and European models. Some American cars do not need to be disassembled. Bar

Step 6: Remove the headlight assembly connector plug on the original car, and pay attention to the difference between the function wire plugs on the original car;

Step 7: Carefully remove the headlight assembly of the original car (can be packaged with the new bi-xenon LED car headlight assembly package), pay attention to the storage and placement of all the mounting screws and buckles;

Step 8: Press the new double Xenon LED car headlights to the body to position, connect all the docking plugs of the xenon lamp group (including parking lights, low beam lights, high beam lights, turn signals, or front fog lights, or Fine-tuning the motor, etc.); start the engine to check whether the functions of the lamp group are normally lit (if the light is not bright, please check whether the plug is plugged in or the connection is bad);

Step 9: If the HID ballast is an external plugger, turn off the engine and the power supply, install it in a well-ventilated position, and do not place it next to the engine to avoid the impact of high temperature on its life;

Step 10: Lock the double Xenon LED car headlights to a firm and reliable position, re-open the engine and power supply, and turn on the HID xenon lamp. Since each car has different conditions, check the left and right lights below the cut-off line. Whether the center point coincides with the center point marked by the original car. If there is a drop, use the "Ten" type screwdriver to fine tune to the position of the low beam center point marked by the original car (the adjustment bar below the general headlight assembly is the dimming type. The outer adjustment rod is dimmable inside and outside);

Step 11: Put the bumper or front grille on the original car back according to the reverse steps of the original disassembly. Note that the screws and buckles cannot be installed.

Step 12: After washing, please rinse and wipe clean.