According to Toshiba, the "E-CORE LED Light Engine" has an outer diameter of 90mm and a height of 48mm. The beam has 1100lm and 1600lm (color temperature is 4000K and 3000K respectively. 2700K is 1050lm and 1600lm). The beam angle is divided into 45. Degree and 85 degrees. The lamp holder with heat dissipation structure (GH76p) was jointly developed by Toshiba and German BJB GmbH & Co. KG.
In combination with an LED module and a lens, to increase the illumination, it is necessary to increase the number of lenses. When the beam of the product reaches 500 lm or more, the size of the lamp increases. Toshiba said that the newly developed luminaire is not only limited in size, but also different from the traditional downlight that illuminates the object due to the use of multiple lenses. When the lamp is used, the shadow of the object can be changed to one. The angle is also determined by the luminaire.
Toshiba said it has developed a new type of lamp that does not require the use of multiple lenses. It can compete with the Philips LED lamp 'Fortimo' and is more advantageous in size and price.
In addition, Toshiba also exhibited seven new products, including small LED lamps that support the light source of traditional light sources and used to replace decorative light bulbs, and small LED bulbs equivalent to Japan's 25W xenon bulbs.
It is understood that LED bulbs are used to replace the Dichroic Halogen bulbs that have a large market in Europe. In addition to the good replacement of the 100V35W halogen bulbs after the market, the replacement of the 12V35W halogen bulbs is also available. product. LED bulbs have been on sale since April 1, 2011, and the installation fee is around 80 Euros.
The insulated terminal is actually a piece of metal sealed inside the insulating plastic. There are holes at both ends to insert the wire. There are screws for fastening or loosening. For example, two wires, sometimes need to be connected, sometimes need to be disconnected. They can be connected by terminals and can be disconnected at any time without having to solder or entangle them, which is convenient and quick. And very beautiful, the cabinet does not look so messy, with an orderly wiring.
classification
Round pre-insulated terminal, cold-pressed terminal block, electric power fitting, fork-shaped pre-insulated terminal, pin-shaped pre-insulated terminal, chip-shaped pre-insulated terminal, bullet-shaped fully insulated terminal, elongated intermediate joint, short intermediate joint, round Bare end, fork-shaped bare end, male and female pre-insulated terminal, tubular pre-insulated terminal, tubular bare end, pin-shaped bare end, peephole series SC, DTG copper terminal, C45 special terminal range insulated terminal Also known as cold-pressed terminals, electronic connectors, air connectors are attributed to cold-pressed terminals.
Insulated Terminal Connector,Ring Terminals,Heat Shrinkable Butt Connectors,Shrinkable Fork Terminals
Ningbo Bond Industrial Electric Co., Ltd. , https://www.bondelectro.com